After assembling your Road Wing, it should look like the photo above.
Your Road Wing package will include:
| Quantity | Item |
| 1 | fiberglass wing |
| 2 | end caps |
| 2 | vertical struts |
| 2 | 24-inch horizontal plate bed rail attachments |
| 4 | H-6 (11/2″ x 1/2″) gold bolts |
| 8 | H-6 (1/2″) gold washers |
| 4 | H-6 (1/2″) gold lock washers |
| 4 | H-6 (1/2″) gold nuts |
| 4 | (11/2″ x 3/8″) silver bolts |
| 4 | 3/8″ Silver Washers |
| 4 | j-bolts with attachments |
| 2 | Screw Covers |
Passenger side strut and horizontal plate with bolts, nuts, and washers.
Installation order: bolt, washer, insert through holes lined up on strut and horizontal plate, washer, lock washer, and nut.
Loosely tighten.
Final tightening after placing on truck rails and lining it in front of the horizontal plate with the front bed rail.
Driver side strut and horizontal plate with bolts, nuts, and washers.
Installation order: bolt, washer, insert through holes lined up on strut and horizontal plate, washer, lock washer, and nut.
Loosely tighten.
Final tightening after placing on truck rails and lining up the front of the horizontal plate with the front bed rail.
Attachment of passenger side struts to the Road Wing using 1 1/2″ by 3/8″ silver bolts and 3/8″ silver washers.
Attachment of the driver side end cap using 3 1/2″ wood screw.
Cover wood screw with the stickers provided.
Note: Drill not required
Attachment of the passenger side end cap using 3 1/2″ wood screw.
Cover wood screw with the stickers provided.
Installation of the J-bolt
Installation of the J-bolt
Installation of the J-bolt
Make sure the strut and horizontal plates that were loosely tightened are tight at this point.
After installation, your Road Wing should look like the photo above.
